12
2. System and operation
SCUBAPRO ALADIN 2G
The following settings may be changed with SmartTRAK or via set 1/set 2/set 3 directly on
Aladin 2G:
Scuba Setting Range Default Page
•
Depth alarm 5 - 100m (20 - 330ft) on/off 40m (130ft),off 58
•
Dive time alarm 5-195min, on/off 60min, off 59
•
Safety stop duration 1-5min 3 minutes 59
•
Maximum partial pressure of
oxygen (ppO
2
max) 1.2-1.6bar 1.4bar 59
•
Time limit to reset the O
2
% mix
to air
no reset / 1 - 48hrs no reset 59
•
Deco gas on/off off 60
•
PDIS (Profile Dependent
Intermediate Stop)
on/off off 60
•
Unit system metric/imperial 60
•
Water type on (salt water)/off (fresh
water)
on (salt water) 60
•
Backlight illumination duration 2-12s ; push on / push off 6s 61
•
Audible attention signals on / off (SmartTRAK:
selective)
on 61
•
Water contacts on / off on 61
•
Reset desaturation on / off no reset 62
•
Gauge mode on / off off 33
•
Alarm clock 0 - 23h 59min, on/off 12:00, off 63
•
UTC (Universal Time Change)
zone
±13hrs, increments: 15min 63
•
Time of day hours:minutes 64
•
24 or AM/PM setting 24 (off) / AM/PM (on) 64
• Date 64
•
Display contrast 1 (low) -12 (high) 4 64
•
IrDA speed setting (only “set 2”) low / high low
65
• Sound
on / off on 65
Apnea Setting
•
Dual Depth alarm 1 5-100m (20-330ft) 10m (35ft), off 66
•
Dual Depth alarm 2 5-100m (20-330ft) 20m (65ft), off 66
•
Incremental depth alarm 5-100m (20-330ft),
way down, way up, both off
5m (20ft), off 66
•
Dive time interval warning 15s-10min, on/off 30s, off 66
•
Surface interval warning 15s-10min, on/off 1 min, off 67
•
Ascent speed alarm 0.1-5 m/s (1-15ft/s) 1 m/s (3 ft/s), off 67
•
Water density 1.000-1.050 kg/l 1.025 kg/l 67
The following data may be recalled with SmartTRAK:
•
Number of past dives • Logbook
•
Total duration of dives • Temperature curve
• Deepest dive • Alarms and attention messages
• Longest dive • Bookmarks
•
Atmospheric pressure • Average depth
• Dive profile • Battery condition
To Next Page
Loading...
Need help?
General
