SCULPFUN SF-A9 - Engraving Parameters and Interface; Engraving Parameter Settings; Engraving Progress and Control

SF-A9 Machine User Manual
① Name the file name
② Adjust engraving size
③ Set engraving speed
④ Set engraving power
⑤ Move laser position
⑥ Engraving preview
⑦ Upload engraving file
⑧ air assist switch
⑨ Engraving mode
M3/M4
(M3 constant power M4
variable power)
① ②
③ ④
⑤ ⑥ ⑦
⑧
① After the upload is
completed, the machine
will start the engraving
task
② Displays the engraving
progress bar, and the
bottom can control the
machine to pause and
start
③ Just wait for the engraving
to be completed
6.4 Engraving parameter settings
6.5 Engraving interface
⑨
14
EN
EN