SDMO PRO 3000 E - Page 13

447_EN.docx 2021-05-28
Section 7. Repairing minor faults
The unit…
Check that:
Solutions to be applied:
Does not start
The equipment to be used has not
been connected prior to starting.
NO
Disconnect the equipment then try to start
the unit again.
YES
The switch is at or .
NO
Set the switch to or .
YES
The battery is correctly connected and
charged.
NO
Install the battery; replace it with a new
battery if necessary.
YES
The fuel tap is in the ON position.
NO
Turn the fuel tap to the ON position.
YES
The spark plug is in good condition and
correctly connected.
NO
Check the spark plug.
YES
Stops
The oil level is correct, the oil cut-out
warning light is off.
NO
Top up with oil.
YES
The fuel level is correct.
NO
Fill up with fuel.
YES
Does not function normally
(noise, smoke, etc.)
Maintenance has been correctly
performed on the unit components.
NO
Perform maintenance on the unit as per
the recommendations.
YES
Have the unit checked by one of our
agents*.
Does not supply electrical
current
The circuit breaker for the 12V socket
is triggered.
NO
Press the circuit breaker for the 12V
socket to trigger it.
YES
The capacity of the unit is not
exceeded; the overload warning light is
off.
NO
Reduce the load.
YES
The connected equipment and their
power cords are not faulty.
NO
Try with another item of equipment and
another power cord.
YES
Have the unit checked by one of our
agents*.
*France: 0.806.800.107 (call charge).
7.1 Cleaning the exhaust silencer
1. Remove the nuts (A4) and the enclosure (A3).
2. Remove the screws (F1) and the cover from the exhaust silencer (F2).
3. Remove the screw (F3) and the exhaust silencer (F4).
4. Remove the exhaust silencer grille (F5) then the spark arrester (F6).
5. Using a metal brush, carefully remove the deposits on the exhaust silencer grille and spark arrester.
6. Check the condition of the spark arrester and the exhaust silencer grille. Replace them if they are damaged.
7. Refit the spark arrester.
8. Refit the exhaust silencer grille and the exhaust silencer by tightening the screw correctly.
9. Refit the exhaust silencer cover and its screws.
10. Refit the enclosure by retightening the nuts correctly.
Section 8. Technical specifications
8.1 Operating conditions
The stated outputs of the units are obtained under the reference conditions outlined in ISO 8528-1(2005):
Total barometric pressure: 100 kPa - Ambient air temperature: 25°C (298 K) - Relative humidity: 30%.
The unit's output is reduced by approximately 4% for every additional 10°C and/or approximately 1% for every additional 100m in
altitude. Units can only operate while stationary.
23/178