SDMO PRO 3000 E - Page 14

447_EN.docx 2021-05-28
8.2 Capacity of the generating set
Before connecting and operating the unit, calculate the electrical power required by the units to be used (in watts)*. To ensure
optimal operation, the total wattage of all equipment used at the same time must be:
- greater than 60% of the rated load for the unit (risk of insufficient load);
- less than the rated load for the unit during continuous operation (risk of overload).
If the unit is run under or over its rated load frequently or for long periods of time, it can start to wear very quickly. Damage caused
in this way will not be covered by the warranty.
*This load is usually indicated in the technical specifications or on the manufacturer's plate for the equipment. Some equipment requires a higher
load when starting. This minimum required power must not exceed the unit's maximum power.
8.3 Generating set identification
The generating set identification plate is affixed to the outside of the enclosure.
Example of an identification plate
(A): Model
(B): CE marking
(C): Maximum
power
(D): Nominal power
(E): Power factor
(F): Earth
(G): Current
amperage
(H): Current
frequency
(I): Current
voltage
(J): Protection
index
(K): Reference
standard
(L): Serial number
(M): Guaranteed acoustic power level
(N): UKCA marking
Serial numbers will be required when requesting troubleshooting advice or spare parts.
To keep them safe, note down the serial number of the generating set below.
Generating set serial number:……../………….. - ……..……..….…. - ………
8.4 Specifications
Model
INVERTER PRO 3000 E PrIndus C5
Maximum power
3000W
Rated output
2800W
Acoustic pressure at 1 m
73 dB(A)
Acoustic measurement uncertainty
0,7 dB(A)
Engine type
MZ175_C5
Maintenance kit
RYS3
Fuel tank capacity
13L
Recommended fuel
Unleaded petrol
Recommended oil
10W30
Oil sump capacity
0,7 L
Oil cut-out*
O
Direct current
12V-12A
Alternating current
230V-12,2A
Circuit breaker(s)**
O
Socket type
2 x 2P+T 230V -10/16A / 1 x 2P -12V -12A
Spark plug type
330830023
Battery
O
Dimensions l x w x h
68 x 44,5 x 55,5 cm
Weight (without fuel)
68 kg
o: standard
x: not available
*Oil cut-out: If there is no oil in the engine sump or if the oil pressure is low, the oil cut-out mechanism automatically stops the engine to prevent any
damage. If this occurs, check the engine oil level and top it up if necessary before looking for any other cause of the problem.
**Circuit breaker: The generating set's electrical circuit is protected by one or more magnetothermal, differential or thermal cut-out switches. In the
event of an overload and/or short circuit, the supply of electrical energy may be cut. If necessary, replace the circuit breakers in the generating set
with circuit breakers with identical nominal ratings and specifications.
(B)
(E)
(F)
(G)
(G)
(H)
(I)
(J)
(K)
(M)
(L)
(A)
(D)
(C)
(N)
24/178