point, but still within zero set range, the scale will set zero automatically;
if out of range, it is necessary to adjust the zero point or recalibrate or
reset.
3.MANUAL ZERO SETTING (automatically)
3.1 In weighing mode, when there is some error when unloaded, press
[TAR/CAL] to make the scale to be zero.
3.2 If the displayed value deviates from zero point, but still within zero
range, pressing [TAR/CAL]key is available. Otherwise, [TAR/CAL] key
is invalid.(In this situation, please recalibrate or reset zero parameters)
3.3 Only when stable sign (on the left corner of display window)
shows, zero operation is available.
4.TARE
When scale is in weighing status, and displaying positive weight stable,
press [TAR/CAL]key, scale will deduct the displayed weight value as tare
weight. Then it displays net weight as "0.0".
5.UNIT OPTIONAL
When at weighing mode, press [UNIT] to change units between g, kg, oz,
lb, t
6.WEIGHING
6.1 Turn on the scale, it displays weighing mode "0.0"
6.2 Put goods on the platter, it will display weight.
To Next Page
Loading...