Need help?Do you have a question about the SDS IDS-802 and is the answer not in the manual?
Place weighing scale on a flat, stable table and adjust rubber feet if needed. Avoid shaking, sun, and EMI.
Turn on scale via [ON/OFF] button; it will self-check and display '0' or '0.0'.
Press [TAR/CAL] to zero the scale when unloaded or if minor deviation occurs, ensuring stability sign is shown.
Press [TAR/CAL] when scale shows stable positive weight to deduct it as tare weight, displaying net weight as '0.0'.
Change weighing units between g, kg, oz, lb, t by pressing the [UNIT] button while in weighing mode.
After scale displays '0.0', place goods on the platter to view the measured weight.
Set average piece weight for counting by placing parts and using [COU/AFF]. Choose sample size via [TAR/CAL].
Scale displays '- - - - -' for overload; remove goods immediately to prevent damage.
Backlight turns off automatically in stable weighing mode to enter auto power-saving status.
To Next Page
General