What does it mean when my Sea-doo GTI Boat beeps 4 times every 3 seconds?
If your Sea-Doo Boat beeps four times every three seconds for four hours, it means the DESS key has been left on its post without starting the engine or after the engine was stopped. To prevent battery discharge, remove the DESS key from its post.
What to do if Sea-doo GTI Boat engine does not turn over?
If your Sea-doo Boat engine isn't turning over, several factors could be at play. First, ensure the safety lanyard is correctly installed on the post. Check the fuses on the MPEM or in the electrical box for the battery, starting system, and fuel pump (DI models), and replace any burnt fuses after checking the wiring. Other potential issues include a discharged battery, corroded or loose battery connections. If the engine is water-flooded, refer to WATER-FLOODED ENGINE in SPECIAL PROCEDURES. Other possible causes may be a faulty sensor (RFI and DI models) or MPEM, a seized engine, or a seized jet pump.
Why does my Sea-doo GTI engine overheat?
Engine overheating in your Sea-doo Boat can stem from several causes. It could be related to issues described in engine OVERHEATS. Other causes may include clogged injectors (RFI and DI models), low fuel pressure (RFI and DI models), or stuck RAVE valves (if so equipped).
What causes cavitation in a Sea-doo GTI Boat?
Cavitation in your Sea-doo Boat can occur for several reasons. The jet pump water intake may be clogged, or the impeller could be damaged. In DI models, the safety lanyard used might be limiting the watercraft's top speed, or the monitoring system might have put the watercraft in limp home mode due to a component malfunction. Clean the intake, replace the impeller, and use a safety lanyard that allows reaching top speed. Releasing the throttle so that the engine returns to idle speed can also help.
What does it mean if my Sea-doo Boat monitoring beeper sounds continuously?
A continuous beep from the monitoring system in your Sea-doo Boat typically indicates either a clogged jet pump water intake or a clogged coolant system. Clean the jet pump water intake and flush the cooling system to resolve this.
Why does my Sea-doo GTI Boat continuously beep?
Your Sea-Doo Boat may beep continuously due to high engine coolant temperature, in which case you should refer to ENGINE OVERHEATING. Alternatively, it could be due to high exhaust temperature.
What to do if my Sea-doo GTI has weeds jammed around the impeller?
Clean and check for damage.
What to do if my Sea-doo GTI Boat engine does not turn over?
If your Sea-Doo Boat engine doesn't turn over, first, ensure the DESS key is correctly installed on the post. Check the main, electric starter, and ECM fuses for any burns and replace them if necessary, after inspecting the wiring. Note that turning over watercraft and water-flooded engine require referring to WATER-FLOODED ENGINE in SPECIAL PROCEDURES and CAPSIZED WATERCRAFT in SPECIAL PROCEDURES.
What does it mean if my Sea-doo GTI (RFI models) beeps every minute?
If your Sea-doo Boat (RFI models) is beeping every minute, it indicates that the fuel tank level is low. Refill the fuel tank.
What does it mean if my Sea-doo GTI beeps every second (DI models)?
If your Sea-doo Boat (DI models) is beeping every second, it indicates that the engine drowned mode is active. Release the throttle to cancel this mode.
General| Manufacturer | Sea-Doo |
|---|---|
| Horsepower | 130 HP |
| Rider Capacity | 3 |
| Fuel Type | Gasoline |
| Fuel Capacity | 15.9 US gal (60 L) |
| Length | 130.3 inches (331 cm) |
Essential rules and recommendations for safe boating operation.
Explains the DESS key operation and security system.
Details the multifunction gauge and its displays.
Recommended fuel types and octane ratings.
Recommended oils, types, and precautions.
Recommended coolant types and mixing.
Table of coded signals, causes, and remedies.
Common causes and remedies for engine not starting.
Troubleshooting for engine running issues and overheating.
Troubleshooting for lack of power and not reaching top speed.
Schedule for regular watercraft servicing and inspections.
Procedures for oil and filter change.
Details warranty coverage, exclusions, and conditions for North America.
Details warranty coverage, exclusions, and conditions internationally.
Details warranty coverage, exclusions, and conditions for EU member states.
To Next Page
