Sea-doo Spark Series User Manual

SAFETY INFORMATION 47
iTC lever
Check operation. (Depress and
release the lever to check for
freedom of movement. If any
friction is felt, the lever must be
taken apart, cleaned, inspected
for wear and lubricated)
iBR lever (if equipped)
Check operation. (Depress and
release the lever to check for
freedom of movement. If any
friction is felt, the lever must be
taken apart, cleaned, inspected
for wear and lubricated)
Front storage compartment cover (if
equipped), glove box and seat
Ensure they are closed and
latched.
Wakeboard rack (if equipped)
– Ensure rack is properly
installed and secured.
– Make sure bungee cords
are in good condition.
– Ensure wakeboard is
correctly installed in rack
and secured.
Ski/wakeboard pylon (if equipped) Inspect and check operation.
Engine START/STOP button Check operation
Engine cut-off switch and the monitoring
beeper
Check operation
Battery condition and connections Check every month
Sacrificial anodes
Inspect every month (more
often in saltwater use) and
change if necessary
Audio System
– Before installation, ensure
latch can move freely and
return to its initial position
– After installation, ensure
audio system is properly
installed and secured
HHuullll
Inspect hull for cracks and other
damages.
JJeett PPuummpp WWaatteerr IInnttaakkee
Remove weeds, shells, debris or any-
thing else that could restrict the flow of
water and damage the propulsion unit.
Clean as necessary. If any obstruction
cannot be removed, refer to an au-
thorized
Sea-Doo dealer for servicing.
PRE-RIDE INSPECTION

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)