Sea-doo Spark Series User Manual

58
EEnnggiinnee SSttaarrttiinngg aanndd SSttooppppiinngg
Refer to Operating Instructions for
complete procedures on how to start
and stop the engine.
WWaakkiinngg UUpp tthhee EElleeccttrriiccaall SSyysstteemm
Press the START/STOP button once
without installing the tether cord on
the engine cut-off switch.
This will power up the electrical sys-
tem; the information center will cycle
through a self-test function.
The electrical system will stay pow-
ered up for approximately 75 seconds
after the START/STOP button was
depressed.
When the tether cord is installed on
the engine cut-off switch, the system
will be powered for 60 minutes.
Every time the START/STOP button is
pressed, the countdown restarts.
When the battery voltage drops below
12.3V, the LOW BATTERY indicator
lamp will light up and the electrical
system will shut down after 75
seconds.
PPoosstt--DDrriivvee BBaatttteerryy MMaannaaggeemmeenntt
This feature allows keeping the elec-
trical system awake to allow using ac-
cessories when the engine is turned
off. It also prevents draining the bat-
tery too much when using accesso-
ries. When the battery voltage
reaches 12.3V or less, the system will
automatically shut down to ensure
being able to start the engine.
When the electrical system is acti-
vated by pressing start-stop briefly
while the engine is shutdown the
wake-up time will be managed as
follows:
– Key off: System will shut down
after 75 seconds.
– Key on: System will shut down
after 60 minutes or if the voltage
threshold is reached.
EEnnggiinnee CCuutt--OOffff SSwwiittcchh
The engine cut-off switch is located on
the RH side of the multifunction
gauge.
To allow engine starting, the tether
cord cap must be securely snapped to
the engine cut-off switch.
WWAARRNNIINNGG
AAllwwaayyss aattttaacchh tthhee tteetthheerr ccoorrdd cclliipp
ttoo tthhee ooppeerraattoorr''ss ppeerrssoonnaall fflloottaa--
ttiioonn ddeevviiccee ((PPFFDD)) oorr wwrriisstt ((wwrriisstt
ssttrraapp rreeqquuiirreedd))..
TTYYPPIICCAALL
1. Tether cord cap on the engine cut-off switch
2. Tether cord secured to operator's PFD
To stop engine, pull the tether cord
cap from the engine cut-off switch.
WWAARRNNIINNGG
SShhoouulldd tthhee eennggiinnee bbee ssttooppppeedd,, tthhee
bbrraakkee ffuunnccttiioonn aanndd aallll wwaatteerrccrraafftt
ddiirreeccttiioonnaall ccoonnttrrooll iiss lloosstt..
CONTROLS

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)