Sea-doo Spark Series User Manual

68
TTYYPPIICCAALL -- SSEEAATT LLAATTCCHH
1. Seat latch handle
Removing the seat provides access to
the rear storage compartment (3UP
models only), operator's guide, the fire
extinguisher (not supplied with ve-
hicle) and the fuel cap.
TTYYPPIICCAALL -- SSEEAATT RREEMMOOVVEEDD
1. Fire extinguisher
2. Fuel cap
TTYYPPIICCAALL -- FFLLIIPP SSIIDDEE OOFF RREEMMOOVVEEDD SSEEAATT
1. Operator's guide
To install the seat, position the seat in
place and push the seat forward until
the latch clicks.
Pull up on the rear portion of the seat
to ensure it is properly latched.
PPaasssseennggeerr HHaannddhhoollddss
The seat strap provides a handhold
for a passenger to hold on to when
riding.
The sides of the molded grab handle
at the rear of the seat also provide a
handhold for a passenger.
The rear portion of the molded grab
handle also provides a handhold for
the skier/wakeboarder spotter (if appli-
cable) or boarding the watercraft from
the water.
NNOOTTIICCEE
NNeevveerr uussee tthhee mmoollddeedd ggrraabb hhaann--
ddllee ttoo ttooww aannyytthhiinngg oorr ttoo lliifftt tthhee
wwaatteerrccrraafftt..
PPAASSSSEENNGGEERR HHAANNDDHHOOLLDDSS
1. Seat strap
2. Molded grab handle
BBooaarrddiinngg SStteepp ((CCoonnvveenniieennccee
PPaacckkaaggee))
A convenient step used for boarding
the watercraft from the water.
EQUIPMENT

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)