Sea-doo Spark Series User Manual

86
VVTTSS CCOONNTTRROOLL BBUUTTTTOONN
1. Bow up
2. Bow down
Pressing the VTS button with the en-
gine OFF, will change the indication in
the gauge but will not change the jet
pump nozzle position. The nozzle will
change position next time the engine
is started and engaged in forward.
The VTS position is displayed on the
multifunction gauge.
1. VTS up display
2. VTS down display
VVTTSS SSeettttiinnggss GGuuiiddeelliinneess
SSeettttiinngg
UUssee
Center
Riding at high
speeds
Down
Compensate
load, obtain
neutral attitude,
reduce
porpoising
VVTTSS SSeettttiinnggss GGuuiiddeelliinneess
SSeettttiinngg
UUssee
Slightly up
Obtain neutral
attitude
Up
Purposely raise
the bow
CCAAUUTTIIOONN
RRiiddiinngg aatt hhiigghh ssppeeeeddss wwiitthh tthhee
VVTTSS aatt hhiigghh sseettttiinnggss ccaann aaffffeecctt
hhaannddlliinngg..
UUssiinngg PPrreesseett TTrriimm PPoossiittiioonnss
Three preset trim positions can be se-
lected (full down, center and full up).
To select the highest trim position re-
corded, double-click on the VTS UP
button (bow up).
To select the lowest trim position re-
corded, double-click on the VTS
DOWN button (bow down).
OPERATING INSTRUCTIONS

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)