Side Motor Mount
(OPTIONAL)
Used for electric motors
and designed so that
the weight of the battery
balances the motor on
the opposite side. Not
intended for use with
gas motors. Assembly
for this motor mount is
the same as the center
motor mount.
Center Motor Mount
(OPTIONAL)
Used for gas and
Torqeedo motors up to
3HP (45 lbs. max).
Attach the L-Brackets to
the motor mount board
and motor mount block
as shown.
Remove the rear yoke
and replace it with the
motor mount board
which goes over the
yoke bolts and secures
with the knurled nuts.
Use the enclosed straps
to secure the motor
mount board. Run the
strap through the D-
rings fore and aft of the
board and tighten.
Doing this will pull the
motor mount towards
the D-Rings fore of the
motor mount board.
Extension Handle
(OPTIONAL)
The extension handle
gives you complete
steering and throttle
control with improved
weight distribution in
your boat. We highly
recommend this for use
with gas and Torqeedo
motors, can also be
used with electric.
Torqeedo 1003s
(OPTIONAL)
Weighing just 29.5 lbs
with a short shaft of 23”,
the Torqeedo Travel
1003s delivers the per-
formance of a 3HP gas
motor and develops 4-5
times the power of tradi-
tional electric
motors.
Minn Kota Motors
(OPTIONAL)
Minn Kota Motors are
the most reliable electric
trolling motors on the
market. These motors
run off a 12v deep cycle
marine battery (which is
not included or sold by
Sea Eagle).
Portable Charger
(OPTIONAL)
Protect and preserve
your battery life with this
portable 10 AMP, Minn
Kota battery charger.
Features fully automatic
3-stage charging.
Weighs 17 lbs.
Input: 120V AC
Output: DC 12V
9
To Next Page
Loading...
