Sea Eagle 435PS - Assembly and Accessory Setup; 4-Part Paddle Assembly; Fishing Swivel Kit Assembly

4-Part Paddle
Each paddle includes
two shafts, two blades
and 2 drip guards.
Its important to follow
the directions exactly as
assembling the paddles
incorrectly may leave
you with an inoperable
paddle that cannot be
disassembled.
Begin by locating the
shaft with 3 pre-drilled
holes and using the
push pin on the other
shaft, join the two shafts
together so that the 3
pre-drilled holes now
form the middle of the
paddle.
The 3 pre-drilled holes
are used for feathering
so that you can position
one blade to 90° from
the other. This makes
paddling into a stiff
breeze easier because
the blade that is not in
the water will be able to
slice through the wind
with little resistance.
Next, slide a drip guard
over each end of the
shaft, positioning the
drip guards so they are
on the outside of your
hands (closest to the
pinky finger). Connect
the paddle blades to the
end of each shaft to
complet
Fishing Swivel Kit
(OPTIONAL)
Includes swivel seat,
seat mount, aluminum
platform, aluminum
crossbar yokes, 2 rod
holders and hardware
for assembly.
Attach the flush mount
adapters for the rod
holders at each end of
the long yoke in the pre-
drilled hole and secure
with a Philips Head
Screwdriver.
Place the swivel seat
mount in the center of
the aluminum board and
then attach it using the
4 small bolts, washers
and wing nuts included
with the hardware bag.
The aluminum board
has 4 pre-drilled holes
in the center for this ap-
plication.
Attach the aluminum
board over the 2 yokes
at and attach using the
2 long bolts, 2 large
washers and 2 black
knurled nuts included
with the hardware bag.
The bolts should be in-
serted from under the
aluminum yoke so the
knurled nuts are on top.
7