6
Sea Eagle Boats Inc. 19 N. Columbia Street, Ste1, Port Jefferson, NY 11777 • 1-800-748-8066 • Staff@SeaEagle.com
EZLite™ Kayaks| ASSEMBLY & INFLATION
Repeat pedal installation
on the other side. Pedal
positions are numbered for
easy alignment. Adjust pedal
while on the water by lifting
pedal with a foot and slide
pedal fore or aft.
Run bar through its hole
in FlexBrace pedal, then
through the pedal and into
the end cap.
Lock the bar in place by ro-
tating the handle down into
the locking hook.
Flip boat over and slide skeg
into skeg base. Skeg must go
in far enough for locking clip
groove to line up with slot in
the skeg.
Push clip into base until it
clicks into place.
Tall Back Seat (TBS)
The TBS is made of thermal
molded foam. Featuring a
storage pouch on the back
with built in zipper, the TBS
provides great lumbar
support with an 18” high
back rest.
When done, replace valve
caps. The caps are part of a
complete seal.
Locate the right (R) and left
(L) pedals and aluminum
bars (9 7/8”).
To Next Page
Loading...