5
Recessed Air Valves
Remove the cap and press
and turn the valve stem
counterclockwise so that
the stem is in the UP
position. When the stem
is in the up position the
valve will retain air. Turn
the stem clockwise and
down to valve for
deflation.
When ready to inflate,
insert valve adapter and
twist clockwise to lock in.
The adapter has a bar that
will hold the valve open
for easy pumping. Do not
inflate until underbars are
installed.
A-41 Foot Pump
Unwrap the hose and press
the two halves to release
the clip. Screw the hose
into the OUT port. Foot
pump rapidly inflates boat.
Cannot not over inflate
boat with foot pump.
Recessed Adapter
The recessed valve adapter
is located inside of the
orange repair kit canister.
Insert the ribbed end of the
valve adapter into the hose
on the foot pump.
Also included are a cluster
of seven valve adapters,
with raised numbers on
each arm of the cluster.
The adapter marked
number 1 is the only
adapter needed for your
Sea Eagle.
INFLATION, VALVES & PUMPS
BTP Turbo & BP12
Electric Pumps
(OPTIONAL)
These electric pumps
come with a nylon
shoulder carry bag, 12V
DC power cord, hose and
adapters.
WARNINGS: Keep out
of the reach of children.
Don’t leave running
unattended. Do not use
inflator for more than 20
minutes continuously as
this can cause overheating
and damage.
Locate the gray adapter
with red gasket. Press
and twist this adapter
firmly onto the gray tube
at the end of the black
hose.
The tube is glued in, do
not try to remove it.
To Next Page
Loading...
