7
Locate an area large
enough to unfold the
boat. Avoid hazards that
could damage the boat or
injure you. If out of
alignment, slide
crossbenches so they are
centered on the
hold-downs.
Stabilizer Underbars
Insert underbars under the
crossbenches, two in the
front, two in the rear.
Align the ends of the
underbars in line with the
triangular markings on
each pontoon.
Note: Bars might not touch
markings.
ASSEMBLY & INFLATION
When properly aligned,
the underbars should line
up underneath the center
crossboard. Bars may not
touch under crossboards.
Once they are in place,
finish inflating the boat to
full capacity.
Swivel Seat
The 375FC has two basic
seating positions with one
at the rear and the other
at the front.
Insert the adapter into the
valve, turn it to the right
until it locks in the
opening. Valve stem must
be in the UP position.
Note: if adapter it too tight
to turn, stretch rubber
gasket until pliable and
retry.
Pump until very firm.
Pontoon should be very
tight with almost no
wrinkles. Floor will be
stretched tight between
pontoons. Use firm even
strokes, do not stomp on
pump. Finished when very
firm resistance from foot
pump is felt.
Quick Release Seat Mount
comes with four 2” bolts
and four wing nuts. A
Phillips head screwdriver
(not included) is needed
to complete installation.
The mount can remain
attached when being
folded for storage and is a
one-time assembly.
To Next Page
Loading...
