Why is my Seabreeze WM18H424ZMI Air Conditioner not cooling properly?
If your Seabreeze Air Conditioner isn't cooling or heating efficiently, ensure the temperature setting is correct. Check for obstructions in the inlet or outlet vents and make sure the filter is clean. Keep windows and doors closed, set the fan to a higher speed, and remove any heat sources from the room.
How to fix a Seabreeze WM18H424ZMI Air Conditioner that won't turn on?
If your Seabreeze Air Conditioner unit isn't running, check the following: * Ensure the power is on. * Check if the circuit protection device has tripped. * Have a professional test if the voltage is too high or low. * Make sure the Timer is off. * Note that a 3-minute delay occurs before each compressor starts.
What to do if Seabreeze WM18H424ZMI Air Conditioner remote is not working?
If your Seabreeze Air Conditioner's wireless remote control isn't working, try the following: 1. Reset the unit by disconnecting the main power for 30 seconds, then reconnect it. 2. Ensure you are within receiving range and that there are no obstructions. 3. Replace the batteries. 4. Check the remote control for any damage.
Why is my Seabreeze Air Conditioner leaking water outside?
Water leakage in the outdoor unit of your Seabreeze Air Conditioner is normal in certain situations. When the unit is running in Auto Defrosting mode, ice will thaw and drip into the pan. Also, when the unit is running in HEAT mode, water adhered to the condenser coil drains into the pan.
Why is my Seabreeze Air Conditioner making noise inside?
The noise emitted from your Seabreeze Air Conditioner's indoor unit is normal in some cases. When defrosting starts or stops, a sound may occur due to the refrigerant flow reversing directions. Also, normal refrigerant flowing in the unit can produce sound.
Read the instruction manual prior to use for proper operation. Installation by licensed technician.
Explains icons for TIMER, SWING, TURBO, SILENCE, anti-cold air, defrosting, clean, freeze protection, temperature setpoint, wireless control.
Instructions for beginning of season, during season (filter cleaning), and after operating season.
Details the function of each button on the remote control (ON/OFF, UP, DOWN, SET, MODE, FAN, SWING, TIMER, etc.).
Instructions for AUTO, COOLING, HEATING, and FAN operations using the remote.
Addresses error codes, fuse/breaker issues, remote problems, unit not starting or cooling/heating satisfactorily.
General| Refrigerant | R410A |
|---|---|
| Outdoor Unit Weight | 42 kg |
| Power Supply | 220-240V, 50Hz |
| Type | Split System |
| Air Flow (Indoor) | 850 m3/h |
| Cooling Capacity | 18000 BTU/h |
To Next Page
