17
ADJUSTABLE LIGHT BEAM WIDTH
The torch has a system that allows users to adjust the angle of the light cone
during use from 12° to 75° by turning the head.
Grasp the handle of the torch firmly with one hand, and with the other grip the
head of the torch where the special rubber ring is located. Rotate one direction
or another depending on whether you want the light beam to be broader or
narrower.
WARNING
During this operation, be careful to grasp the base of the torch firmly
and do not touch the end cap, because unscrewing this could cause the
torch to flood.
WARNING
Strictly follow the polarity markings when inserting the battery!
INSERTING THE BATTERY
• Unscrew the aluminum cap at the end of the handle, turning counter-
clockwise.
• Remove the plastic charging ring, turning counter-clockwise.
• Insert the battery, making sure that the positive pole (+) is pointing into
the torch.
• Grease the sealing O-rings with a layer of silicone grease.
• Screw the plastic recharging ring nut back on clockwise, taking care not to
damage the threading while doing so.
• Screw the aluminum terminal at the end of the handle back on, turning
clockwise.
WARNING
Failure to fully tighten this cap could result in water leaking into the torch
during use.
• Check that the torch switches on using the switch.
14797 - Manuale Seac torce serie R20 R30 R40 - TOTALE.indb 17 11/09/2018 10:50:20
To Next Page
Loading...
