Need help?Do you have a question about the Seagate IRONWOLF ST6000VN001 and is the answer not in the manual?
Explains the advantages and features of the Serial ATA interface.
Provides a quick reference table of key drive specifications.
Specifies the usable storage space available on the drive after formatting.
Details the drive's physical dimensions, weight, and cache buffer size.
Details power consumption, conducted noise, voltage tolerance, and power management modes.
Covers operating and non-operating conditions for temperature, humidity, shock, and vibration.
Describes the sound power levels and testing for drive acoustics.
Specifies the drive's performance under various radio frequency environments.
Explains how to determine the warranty status for a specific drive.
Lists regulatory compliance and safety certifications for the drive.
Outlines essential safety measures for handling the drive to prevent ESD damage.
Provides instructions and precautions for physically mounting the drive into a system.
Explains the drive's ability to be connected and disconnected while the system is running.
Details the pin assignments for the SATA interface and power connectors.
Lists the various ATA commands supported by the drive for communication.
Details the information returned by the Identify Device command, including drive parameters.
Explains how to configure various drive features using the Set Features command.
Explains Self-Monitoring, Analysis, and Reporting Technology commands for drive health monitoring.
General| Type | HDD |
|---|---|
| HDD size | 3.5 \ |
| Hot-swap | No |
| HDD speed | 5400 RPM |
| Interface | Serial ATA III |
| HDD capacity | 6000 GB |
| Component for | NAS |
| Average latency | 6 ms |
| Start/stop cycles | 600000 |
| Noise level (idle) | 2.7 dB |
| HDD number of heads | 8 |
| Workload rate limit | 180 TB/year |
| Storage drive buffer size | 256 MB |
| HDD interface transfer rate | 6 Gbit/s |
| HDD sustained transfer rate | 190 MiB/s |
| Error Recovery Control (ERC) | Yes |
| Mean time between failures (MTBF) | 1000000 h |
| Uncorrectable Bit Error Rate (UBER) | \u003C 1 per 10^14 bits read |
| Operating shock | 70 G |
| Non-operating shock | 250 G |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 5 - 70 °C |
| Storage relative humidity (H-H) | 5 - 95 % |
| Operating relative humidity (H-H) | 5 - 90 % |
| Operating voltage | 5 / 12 V |
| Power consumption (idle) | 3.4 W |
| Power consumption (typical) | 5.3 W |
| Harmonized System (HS) code | 84717050 |
Weight and Dimensions| Depth | 146.99 mm |
|---|---|
| Width | 101.85 mm |
| Height | 26.11 mm |
| Weight | 610 g |
To Next Page