Seagate Mobile HDD Product Manual, Rev. D 9
Drive Specifications
2.1 Formatted Capacity
2.1.1 LBA mode
When addressing these drives in LBA mode, all blocks (sectors) are consecutively numbered from 0 to n–1, where n is the number of guaranteed
sectors as defined above.
Refer to Configuring and Mounting the Drive on page 20 (words 60-61 and 100-103) for additional information about 48-bit addressing support
of drives with capacities over 137 GB.
Altitude, non-operating
(below mean sea level, max)
–304.8 m to 12,192 m (–1000 ft to 40,000+ ft)
Operational Shock 400 Gs at 2 ms max
Non-Operational Shock 1000 Gs at 1 ms max
Vibration, operating
5–200 Hz: 2.0 Gs
201–500 Hz: 1.0 Gs
Vibration, non-operating 5–500 Hz: 5.0 Gs
Nonrecoverable read errors 1 per 10
14
bits read
Rated workload
Average annualized workload rating: <55 TB/year.
The AFR specification for the product assumes the I/O workload does not exceed the average
annualized workload rate limit of 55 TB/year. Workloads exceeding the annualized rate may
degrade the product AFR and impact reliability as experienced by the particular application. The
average annualized workload rate limit is in units of TB per calendar year.
Warranty
To determine the warranty for a specific drive, use a web browser to access the following web
page: http://www.sea
gate.com/support/warranty-and-replacements/.
From this page, click on the “Is my Drive under Warranty” link. The following are required to be
provided: the drive serial number, model number (or part number) and country of purchase. The
system will display the warranty information for the drive.
Load-unload cycles 600,000 at 25°C, 50% rel. humidity
Supports Hotplug operation per the
Serial ATA Revision 3.2 specification
Yes
1. One GB equals one billion bytes when referring to hard drive capacity.
Accessible capacity may vary depending on operating environment and formatting.
† Seagate does not recommend operating at sustained case temperatures above 60°C.
Operating at higher temperatures will reduce useful life of the product.
Model
Formatted Capacity
(1)
1. One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary
depending on operating environment and formatting.
Guaranteed Sectors Bytes per Sector
2TB model 2000 GB 3,907,029,168
512 (logical) /
4096 (physical)
1TB model 1000 GB 1,953,525,168
500GB model 500 GB 976,773,168
Table 1 Drive Specifications Summary (continued)
Drive Specification
ST2000LM007, ST2000LM009
and ST2000LM010
ST1000LM035, ST1000LM037
and ST1000LM038
ST500LM030
To Next Page
Loading...
