To Next PageTo Next Page
Need help?Do you have a question about the Seagate ST900MM0006 and is the answer not in the manual?
Details standards and documents relevant to Savvio SAS drive specifications and compliance.
Lists supporting manuals and standards for SAS interface and commands.
Lists the standard features of Savvio 10K.6 SAS drives.
Covers media description, performance metrics, and reliability specifications.
Details the formatted capacities for various sector sizes and models.
Explains how to change drive capacity using the Mode Select command.
Lists optional features available at manufacturing.
Details the internal physical and electrical characteristics of the drives.
Provides general performance data like format times and transfer rates.
Describes the time taken for drive spin-up and spin-down operations.
Explains cache and prefetch operations, including write caching.
Details the types and rates of data errors encountered by the drive.
Covers AFR, MTBF, maintenance, hot-plugging, S.M.A.R.T., and warranty.
Describes the drive's self-test functionality for fault detection.
Provides information on drive warranty, shipping, and repair.
Details the drive's power management features and modes.
Specifies voltage and current requirements for drive operation.
Defines immunity to electrical noise across various frequencies.
Provides typical power dissipation figures for different models and speeds.
Specifies operating and non-operating temperature and humidity ranges.
Defines limits for shock and vibration during operation and transit.
Outlines requirements for air cleanliness for drive operation.
Details the AES-256 encryption engine used for data protection.
Explains security providers (Admin SP, Locking SP) and authentication.
Describes the hardware RNG for key generation and password derivation.
Covers features to prevent unauthorized access and firmware manipulation.
Explains how drive defects are identified and managed internally.
Details the drive's mechanisms for recovering from read/write errors.
Describes the self-initiated media scan for verifying data integrity.
Explains how unreadable locations are handled on subsequent writes.
Covers standardized data integrity checks using extra bytes.
Discusses drive mounting orientations and cooling requirements.
Provides instructions and specifications for physically mounting the drive.
Details grounding requirements for proper operation and signal integrity.
Lists SAS-specific features supported by the drives.
Explains the functionality of the drive's two independent SAS ports.
Lists the SCSI commands compatible with the Savvio drives.
Covers various operating features and status conditions.
Defines the physical characteristics of the SAS interface connector.
Provides information on mating SAS connectors.
Details the electrical functions of the SAS connector pins.
Lists and describes the function of each pin in the SAS connector.
Describes the drive's Ready LED output signal behavior.
Details compliance with SAS differential signal requirements.
Confirms compatibility with the SAS-2 specification.
General