Seakeeper 1 - Page 14

OPERATION
MANUAL
Product:
Document #:
Rev:
Page:
SEAKEEPER 1
90520
1
14 of 22
Section 2: SYSTEM OPERATION
The Seakeeper should be stopped when stabilization is no longer
required. Once the vessel is secured in the slip, the high and low current
DC power to the Seakeeper should be switched to the Off position. The
Seakeeper will continue to spool down to 0 RPM. No cooling is required
during this time. Note Seakeeper will take 2+ hours to coast down to 0
RPM from full speed.
Note: The seawater pump may run for up to 5 minutes after the
Seakeeper is switched off and is coasting (with low current DC power
applied).
!