EasyManua.ls Logo

Seakeeper 1 - Maintenance; 4.1 General Maintenance

Seakeeper 1
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION
MANUAL
Product:
Document #:
Rev:
Page:
SEAKEEPER 1
90520
1
18 of 22
Section 4: MAINTENANCE
4.0 INTRODUCTION
Reference Documents & Drawings:
90026, Service Bulletin, Seakeeper Paint Information
SWI-108A Angle Sensor Calibration
90426, Service Bulletin, Seakeeper Scheduled Maintenance Plan
90405, Service Bulletin, Seakeeper Winterization Process
4.1 MAINTENANCE
Seakeeper recommends a regular inspection interval and scheduled maintenance to keep the
Seakeeper 1 running trouble-free.
If
the Seakeeper is installed in a wet space, efforts should be made to keep the Seakeeper free of salt
residue from either condensation or direct exposure to salt spray. If exposed, a regular wipe down
with mild soap and water with a rinse will help limit corrosion and keep the Seakeeper assembly in
good cosmetic condition. Refer to Service Bulletin 90106 for details.
If
any components of the Seakeeper or its sub-systems will be exposed to environmental
temperatures where winterization is necessary for storage, reference Seakeeper service bulletin
90405.
T
he Seakeeper comes standard with sealant and thread locker on applicable fasteners. When
reinstalling all fasteners, use thread locker (Loctite 243 or equivalent) and sealant unless otherwise
specified.
4.2 RECOMMENDED SCHEDULED MAINTENANCE TABLE
The following pages contain the scheduled maintenance table organized by systems: Mechanical,
Hydraulic, Cooling, and Electrical. Recommended scheduled maintenance is not covered under
warranty.
The Recommended Scheduled Maintenance should be performed by a SEAKEEPER trained
factory technician or trained technician within the Seakeeper Dealer network. Find a local
Dealer on our www.seakeeper.com/find-us/
.
A Seakeeper technician or Dealer is required to perform a brake service and to replace
b
rake bushings or other brake components. This requires a complete flush, bleed, purge
and pressurization of the closed hydraulic system.
Scheduled Maintenance and the replacement of ‘wear’ items are not covered by th
e
w
ww.seakeeper.com/extended-warranty/recreation-warranty/
.

Other manuals for Seakeeper 1

Related product manuals