Seakeeper 1 - Page 19

OPERATION
MANUAL
Product:
Document #:
Rev:
Page:
SEAKEEPER 1
90520
1
19 of 22
Section 4: MAINTENANCE
SYSTEM / COMPONENT
TASK
INTERVAL
PARTS / SPECIAL TOOLS
Mechanical / Corrosion
Inspect unit for severely corroded
areas and clean and touch up
with paint. See Service Bulletin
90026.
12 Months or
1000 Hours
Awlgrip Paint P/N’s:
Primer: S9001
Primer Converter: S3001
Top Coat, Snow White:
F8063
Top Coat Converter:
G3010
Mechanical / Safety Latch
Seakeeper or Dealer inspect
safety latch for wear, alarm will
indicate when LIC exceeds 90,000
instances, found on Info Page of
the Seakeeper Application.
Inspect at 12
Months or 1000
hours. Replace
at 2000 hours or
when LIC
exceeds 90,000.
Hydraulic / Brake Actuator Inspect for leaks.
12 Months or
1000 Hours
Cooling / Hoses
Check for cracks or chafing. If
damaged, replace hose. Fill
cooling system and purge air.
12 Months or
1000 Hours
Anti-freeze – 50/50 Ethylene
Glycol mix.
Cooling / Seawater side
Inspect heat exchanger for signs
of leaks.
3 Months or 150
Hours
Cooling / Seawater side
Fill with environmentally safe,
marine anti-freeze during winter
or periods of in-operation.
Winter
Electrical / Connectors
Inspect all connectors for
corrosion, replace if necessary.
12 Months or
1000 Hours
Electrical / Grounds
Inspect all ground points for
corrosion, clean as necessary, and
treat with corrosion inhibitor.
12 Months or
1000 Hours
Electrical / Cables
Check all cables and wire harness
branches for cracks or chafing.
Take special attention to gimbal
shaft areas.
12 Months or
1000 Hours
Electrical / Motor Power
Check integrity of motor power
and motor ground conductors.
12 Months or
1000 Hours
Hydraulic / Brake Bushings
Replace brake bushings
Inspect at 12
Months or 1000
Hours – Replace
as needed or at
2000 Hours
Cooling / System Cooling system flush
12 Months or
1000 Hours
Fill reservoir, antifreeze –
50/50 Ethylene Glycol mix