Section 2: SYSTEM OPERATION
2.2 Start-up
1) Make sure AC and DC power are available.
2) Turn on the boat’s DC circuit breaker that supplies power to the Seakeeper.
3) Turn on the boat’s AC circuit breaker that supplies power to the Seakeeper.
4) In most cases, the seawater pump will be wired to turn on when the Seakeeper is turned
on. However, in some cases the seawater pump is on a separate AC or DC circuit
breaker and it is necessary to turn it on.
5) When the DC power is turned on the DISPLAY will initialize and the HOME screen will
appear. If a FAULT is present an ALARM screen will appear.
To turn the Seakeeper ON depress the POWER ON/OFF FAULT RESET button, the
button will turn GREEN, the flywheel will spin (or arrow appear), and a RED
PROGRESS BAR will appear. The PROGRESS BAR indicates how soon the Seakeeper
will be available for stabilization. When the Seakeeper is initialized and when the
Seakeeper is up to minimum operating speed the PROGRESS BAR will turn from RED
to GREEN. At this point, the Seakeeper is available for stabilization.
To Next Page
Loading...
