Seakeeper Ride - Page 3

2. Software Module Switches
For Seakeeper Ride to connect properly to the Multifunction Display (MFD), the switches on the
Software Module must be in the correct positions. Access the switches by removing the rubber
covering on the upper left side of the Software Module.
Do not move Switch 2. Follow the table below to congure Switch 1 based on the MFD brand. The
‘on’ position is to the left.
Garmin, Raymarine, Furuno Switch 1 O
Simrad, Lowrance, B&G, Switch 1 On
6/21/24, 9:02 AM
Seakeeper Ride | Commissioning Instructions – Seakeeper Manuals
https://manuals.seakeeper.com/ride/seakeeper-ride-commissioning-instructions/?print=true
3/41