10. Testing the System
Once the system has been congured, test that the system is operating correctly. While testing the
system, make sure the boat is stationary and has GPS connection. Testing is best done with the boat
out of the water, allowing the Controllers to be seen more clearly. If the Seakeeper Ride system does
not perform as indicated in any of these steps, return to the previous sections and repeat the
associated procedures as necessary.
Note: Pressing the left and right directional arrows move the Blade, blue ll bar, and Keypad lights
on the opposite side. For example, pressing the left, or port side, arrow will change the starboard
side blue ll bar.
1. Enter Manual Mode by pressing the Seakeeper Logo in the center of the directional arrows on
the Home Screen of the display or the Keypad.
2. Look over the transom of the boat to visually conrm the Controller’s Blades are fully retracted
and ush with the Seal Plate.
3. Use the up directional arrow to fully deploy the Blades. The blue bars on the screen should be
lled in with blue completely. Look over the transom of the boat to verify the Controller Blades
have deployed completely.
4. Use the down directional arrow to retract the Blades completely.
5. Press the right directional arrow until the port side blue bar lls in completely.
To Next Page
Loading...
