6. Visually conrm that the port Controller’s Blade is deployed completely.
7. Repeat steps 5-6 for the left directional arrow corresponding to the starboard Controller.
The Seakeeper Ride system commissioning is now complete. Please refer to the Quick Start Guide to
begin using the Seakeeper Ride system.
Note: The speed of the boat, GPS connection, and the system being in Auto or Manual mode will all
inuence how Seakeeper Ride behaves. Even if Seakeeper Ride is set up correctly, the Controllers
may have limited range based on these factors. Refer to the table below for more information, and
see the Seakeeper Ride Operation Manual Section 2.1 and Section 2.2 for home screen controls.
Auto Mode Manual Mode
Speed (with GPS signal)
0-10 mph
Blades can be moved fully
together by trimming with
the up and down directional
arrows. The left and right
directional arrows will apply
a trim to the system but will
not cause the Blades to
move at these speeds. The
Blades will not move
automatically.
Blades can be moved fully
with the directional arrows.
10+ mph Blades will deploy
automatically based on
movement of the boat and
the TCC. At higher speeds,
the Blades will deploy less.
Blades can also be manually
Blades can be moved fully at
lower speeds and will allow
less movement at higher
speeds.
To Next Page
Loading...
