EasyManua.ls Logo

Sealey pc310 - CARPET CLEANING

Sealey pc310
5 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PC310|Issue8(H,F,1...)08/08/2019
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
9.3. STORAGE
NOTE: Prior to storage, the following steps should be taken:
9.3.1. Remove the shampoo head and use the end of the extension
tube to suck up any remaining liquid. Run the vacuum
cleaner until the tubes and hose are clean and dry.
9.3.2. Switch off the unit and unplug from the power supply. Then
empty the main tank and shampoo tank.
9.3.3. Gentlyremovethefoamltertodry.Retforfurtherwet
suction.Fordryvacuumingyoumusttadrycartridgelter.
10. MAINTENANCE
10.1. GENERAL MAINTENANCE
WARNING! Ensure the machine is unplugged from the power supply.
10.1.1. Disconnectthehosefromthecontainer(g.7.2).
10.1.2. Undotheclaspsandremovemotorheadfromthecontainer(g.7.3).
10.1.3. Clearoutanydirtordebrisfromthecontainerandhose(g.7.4).
10.1.4. Cleanthefoamlterbywashingitinamildsoapysolution(g.7.5).
10.1.5. Check that the telescopic suction tube operates smoothly, and check
the power cable to make sure it has not received any damage.
10.1.6. ChecktheORing(g.8)onthemailhoseconnector(Item33)forwear.
10.1.7. Replace O rings if necessary (Item 32).
10.2. CARTRIDGE FILTER MAINTENANCE See also Section 6
10.2.1. Handletheltercarefullywhencleaningorinstalling.
10.2.2. Carefullyremovethecartridgelter(g.9A)andinspectitfordamage.
Alterthathassmallholesortearsinitwillnotperformefciently
and should be replaced.
10.2.3. Tocleanadrylter,tapitinsideawastebin(g.9B).
8 DO NOTuseawetcartridgelterfordryvacuumingas
thelterwillclogquickly.Tocleanawetcartridgelterit
shouldberinsedfromtheinside(g.9B)andallowedtoair
dry for 24 hours.
10.3. Totanew/cleanedlter,slideitoverthelterbasket(g.9C)
andpushithomefully(g.9D).
10.4. Checkandclean,ifnecessary,theexhaustlter(Item3),foundattherearofthemotorhead,beforeeachuse.Openthe
exhaustoutletcover(Item2)andremovetheexhaustlter,cleanwithabrushorblowwithair,replacebeforeswitchingmachineon.
11. TROUBLESHOOTING
Problem Reason Solution
Cleaner will not operate. No power supply.
Faulty power cable, switch or motor.
Container full of liquid.
Check supply.
Check and repair or replace faulty item.
Empty container.
Dust comes from the motor cover. Filter missing or damaged. Fitorreplaceappropriatelter.
Reducedefciencyandincreased
Motorspeed/vibration.
Filter clogged.
Nozzle, hose or container inlet blocked.
Cleanorreplaceappropriatelter.
Check nozzle, hose and container inlet for
blockage.
No solution spraying out. Switch in wrong position.
Shampoo tank is empty.
Incorrectlyttedtriggerorpipes.
Turn switch to the required position.
Add more shampoo.
Checkttingsandconnections.
Ensure there are no kinks in tubes.
Leak from drum connector. O ring on male connector damaged. Replace O ring.
g.7
g.8
g.9
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.

Other manuals for Sealey pc310

Related product manuals