GEAR OIL TRANSFER PUMP & FIXING KIT FOR
EP80 GEAR OIL DRUMS
MODEL NO’S: TP67 & TP67/X
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure all health and safety, local authority, and general workshop practice regulations are strictly adhered to when
using this equipment.
9 Familiariseyourselfwiththeapplicationandlimitationsofthisproduct,aswellasthespecicpotentialhazardspeculiartothearea.
9 Ensure safety eye protection and protective clothing are worn when using this product.
9 Keep the work area clean, uncluttered and ensure there is adequate lighting.
9 Dispose of waste liquids in accordance with local with local authority regulations.
8 DO NOT use the pump to transfer solvents, (see application below).
8 DO NOT use the pump for any purpose other than for which it is designed.
8 DO NOT place the oil drum on an uneven surface, or in contact with any heat source.
8 DO NOTattempttomovetheoildrumbypullingontheoilsupplyortheuidtransferhose.
9 Keep the pump clean and store in a safe dry location when not in use.
2. INTRODUCTION
TP67: Self-priming pump with polypropylene body. Suitable for pumping gear-oil or other products with a similar viscosity. Includes 1.5m of hose
and universal adaptor.
Note: If the container you have will not accept direct mounting of Model No. TP67, order a Model No. TP67DT Trolley and a TP67/X Top Plate.
Thepumpxestothetopplatewhichinturnmountsontothetrolleyandavoidstheneedtoconnectthepumpdirectlytothecontainer.
TP67/X: FixingKitforEP80GearOilDrumsforusewithModelNo.TP67GearOilTransferPump.
3. APPLICATIONS
Note: As a rule if the chemical you want to pump is delivered in a plastic container then you can use a plastic pump to transfer it. The
TP67 and TP67/X can not be used for the transfer of solvents. The unit will handle most disinfectants, detergents, pesticides,
degreasers, mild acids, alkalis, oils, weed-killers and chemical additives. If in doubt as to the suitability of use with a particular
substance contact your local Sealey supplier for advice.
4. ASSEMBLY
Refer to
instruction
manual
TP67, TP67/X Issue:2 27/11/23
Original Language Version
© Jack Sealey Limited
fig.1 TP67 Gear Oil Pump
fig.2 TP67/X Adaptor kit
PARTS LIST Refer to figs 1 & 2.
ITEM PART NO DESCRIPTION
1 TP67 Pump assembly
2 TP67.02 Hoseassembly
3 TP67/03 2”BSPadaptor
4 TP67/04 Locknut
5 TP67/05 Trisureadaptor
6 TP67/06 Multi-neckadaptor
7 TP67/07 Clamppad
8 TP67/08 Clampingscrew
9 TP67/X Washer
10 TP67X Lid(spinning)
To Next Page
Need help?
General