1) Allowed INC Monitors
From Configure Monitors screen, use the SCROLL button to select
Allowed INC Monitors, and press the ENTER/Exit button.
Emissions tests vary depending on the geographic or regional area in
which the vehicle is registered. So the code reader provides a more
flexible way to meet different standards, which allows the user to
select 0, 1, 2, 3 „not complete‟ monitors in test.
2) Reset Factory Default
From Configure Monitors screen, use the SCROLL button to select
Reset Factory Default, and press the ENTER/Exit button.
It will restore the default configuration settings in the Configure
Monitors menu, and delete any customized settings. In this case, the
Allowed INC Monitors will be set to 1.
The tool will display an information message to ask for your
confirmation. Select Yes to proceed and No to exit without change.
Unit of Measure
Metric is the default measurement unit.
1) From System Setup screen, use the SCROLL button to select
Unit of Measure and press the ENTER/Exit button.
2) From Unit of Measure screen, use the SCROLL button to select
the desired unit of measurement. (Figure 3.5 )
To Next Page
Loading...