Need help?Do you have a question about the SEALINE S28 and is the answer not in the manual?
Details the physical measurements, fuel, water, and gas capacities of the vessel.
Covers maximum load, person capacity, and engine power ratings for the boat.
Lists the specifications for the boat's battery and shore power systems.
Outlines essential safety requirements for hull integrity, stability, and structural integrity.
Details safety standards for fuel, gas, fire, steering, and electrical systems.
Defines design categories (A-D) and explains maximum load limits for safe operation.
Provides key recommendations for crew training, load management, and safe boating practices.
Defines safety terms (DANGER, WARNING, CAUTION) and common hazards.
Covers boarding, repairs, modifications, and lifting procedures for safe operation.
Addresses hinge mechanism safety, flybridge operation, and discharging procedures.
Details dealer responsibilities and the scope of the manufacturer's guarantee.
Explains the routine for reporting complaints and managing repairs.
Identifies the locations and types of fire extinguishers on board.
Describes the engine compartment automatic fire suppression system and its operation.
Lists the owner's duties regarding fire fighting equipment and crew awareness.
Explains the battery charger, alternators, and battery self-discharge.
Details the AC and DC main power panels, including RCD and circuit breakers.
Guides on connecting to shore power and performing polarity checks for safety.
Describes the 12V DC system breakers and the function of helm panel switches.
Information on types of lights, their circuits, and lamp replacement.
Instructions for operating the bow thruster and associated safety notes.
Details on using the electric windlass, its power source, and maintenance.
Explains the function of bilge pumps, float switches, and strainers.
Provides solutions for common problems like circuit breaker trips and low flow.
Guidance on maintaining the shower sump and waste collection system.
Covers procedures for starting, running-in engines, and safety switches.
Explains engine instrumentation, throttle controls, and power trim operation.
Details propeller installation, corrosion protection, and stern drive care.
Covers hydraulic steering maintenance, including checking oil and bleeding the system.
Describes the power assisted steering system and its basic maintenance.
Details fuel tanks, filters, valves, fillers, and the venting procedure.
Provides critical safety guidelines for refuelling and routine system checks.
Explains the gas locker, regulator, FFD, and safe cylinder replacement.
Guidelines for using gas appliances and ensuring adequate cabin ventilation.
Recommends annual checks by a registered gas installer.
Details the hot water system, water pump, and tank level indicators.
Provides procedures for bleeding the water system and addressing common issues.
Explains the operation of the shower drain and waste collection system.
Instructions for using the sea toilet and managing discharge sea cocks.
Describes the purpose and disposal methods for waste and grey water tanks.
Information on Sealine's GRP construction and basic exterior cleaning methods.
Care instructions for the canopy, cockpit upholstery, and windows.
Guidance on maintaining deck fittings and installing new equipment.
Methods for cleaning and maintaining wooden, fibreglass, and laminated surfaces.
Instructions for cleaning upholstery and removing common stains.
Key steps for preparing the boat for winter lay-up.
Specific instructions for winterizing engines, stern drives, and fuel systems.
Procedures for winterizing gas, water, and toilet systems to prevent freezing.
Covers hull cleaning, antifouling, anodes, and anchor gear maintenance.
Details the principal measurements of the boat, including length and height.
Provides information on fuel capacity, water tank capacity, and the boat's dry weight.
Visual representation of the deck layout with key features identified.
Explains the purpose and location of numbered components on the deck plan.
Lists and describes the location of various equipment and systems on the boat.
Pinpoints the location of fuel shut-off valves, gas controls, and the gas locker.
Identifies the location of battery switches, circuit breakers, and bilge pump controls.
Provides a diagram identifying all components within the boat's gas system.
Diagram and list of components for the single petrol engine fuel system.
Diagram and list of components for the twin petrol engine fuel system.
Diagram and list of components for the single diesel engine fuel system.
Diagram and list of components for the twin diesel engine fuel system.
Diagrams and identification of components for black and grey water disposal systems.
Guides on proper trim tab operation, including conditions and safety warnings.
Explains the colour codes used for electrical wiring throughout the diagrams.
Provides a list of numbered components referenced in the wiring diagrams.
To Next Page
General