Why does my SealMaster CRACK PRO 260 Construction Equipment diesel burner have low operating PSI?
A low operating PSI in your SealMaster Construction Equipment diesel burner could be due to several factors: * The pump might be worn (check and replace). * The fuel line could be plugged (clean or replace). * The pump coupler might be broken (replace coupler). * The burner motor could be worn (replace motor).
What to do if my SealMaster Construction Equipment hose has no pressure?
If the hose on your SealMaster Construction Equipment has no pressure, it could be due to: * Worn pump gears (replace pump gears). * A worn hydraulic motor (replace hydraulic motor). * The pump shaft not turning (check wiring and fuse).
How to fix a material pump that is leaking on SealMaster CRACK PRO 260?
If the material pump is leaking, you should tighten and replace the packing.
What to do if the burner does not light on my SealMaster Trucks?
If the burner on your SealMaster Trucks doesn't light, several issues could be the cause. Here's a list of things to check: * If the battery is low, replace it. * If the blower motor is slow, check the blower wiring for power. * If the CAD cell is dirty, clean the glass lens. * If the coupler is damaged, replace it. * If the burner is in lockout, remove the negative cable and reattach it. * If the fuel filter is plugged, clean it as needed. * If there is a blower fan, check for obstructions. * If the green light is on, check all of the above.
Why is the agitator not rotating on my SealMaster Trucks?
If the agitator on your SealMaster Trucks isn't rotating, it could be due to several reasons: * The shutoff valve might be closed; if so, open the valve. * The hydraulic oil level might be low; if so, fill the oil to 4 inches from the top of the tank. * The splined coupler might be worn; if so, replace the coupler. * The hydraulic motor might be faulty; if so, replace the agitator motor. * The hydraulic pump might need testing or replacement; have it tested or replaced.
What to do if the high temperature light is on in SealMaster Trucks?
If the high temperature light is on in your SealMaster Trucks, it means the oil is at a high limit. Lower the setting to 475°.
What to do if the burner does not light on my SealMaster CRACK PRO 260 Construction Equipment?
If the burner on your SealMaster Construction Equipment doesn't light, there could be several reasons: * The electrodes might be worn at the tips (replace electrodes). * The electrode spacing might be incorrect (reset spacing). * The CAD cell might be dirty (clean glass lens). * There might be water in the fuel (replace fuel and filter). * The burner might be in lockout (remove negative cable and reattach). * The fuel filter might be plugged (clean as needed). * There might be air in the pump (open bleeder). * The transformer might be worn (replace transformer). * The primary control might have failed (replace primary control). * The fuel solenoid might have failed (replace solenoid). * There might be no power from the controller (trace wires). * The hi-temp light ...
Details the warranty terms and conditions for the product.
Essential safety measures and warnings for operating the machine.
Procedures for immediate medical attention in case of accidents or injuries.
Essential pre-use checks to ensure the machine is ready for operation.
Details on engine oil, hydraulic oil, and heat transfer oil specifications.
Heat transfer oil specs, capacity, and checking procedures.
Common problems and their potential causes and solutions.
Recommended maintenance tasks and their frequency for optimal performance.
Startup checklist, engine starting, and temperature control.
Adding material, temperature management, and applying sealant.
Steps for dispensing and pouring the heated material.
Setting and monitoring temperatures for the double pumper unit.
General| Brand | SealMaster |
|---|---|
| Model | CRACK PRO 260 |
| Category | Construction Equipment |
| Language | English |
To Next Page