Seamax Portable12V Electric Air Pump for Inflatable SUP & Paddle Board www.seamaxmarine.com 1877-907-7766
Page 2
Important Notice
To guard against injury, basic safety precautions should be observed.
To avoid possible electrical shock or fire, special care should be taken when using near the gas, fuel or
metal. Do not use the pump closed to fuel tank, gas tank or an open flame.
Keep the pump away from Children. Store the pump in a dry and cool area away from water and heat.
Do not continue operating the pump for more than 20 minutes. Pump should automatically shut off to cool
itself down when it reaches the 20 minutes continuous operation limit. We suggest user let the pump cool
down for 30 minutes before next use. Otherwise, the pump may automatically stop again to protect its
internal components to avoid overheating issue.
You may need to know:
Pump’s Max Pressure can reach 20 PSI (1.378 Bar /138 Kilo-Pascal). The pressure setting can be saved in
the pump memory when power is disconnected. Please make sure to recheck the pump pressure setting
before every use.
Before connecting the pump to a battery, please make sure the battery voltage is 12V. The max loading of
power source can support a 10A current. The pump requires a minimum 12V/5AH battery to operate
properly.
Always check the air hose, valve connector, and your inflatable product condition before using the pump.
You can connect the pump to a car cigarette lighter port or boat 12V DC socket. If you use a portable
battery, please make sure the battery is fully charged before your trip.
This pump may make some loud sound because of the high pressure dual cylinders pumping unit. This is
normal since the pump is not powered by a high volume turbo fan.
If you wanted to return the pump, you should first contact with Seamax Marine or the authorized dealer
that you purchase it from. Repairs can be performed only by an authorized service technician. The
manufacturer is not responsible for any damage caused as a result of improper use or failure to observe
these instructions.
The pump’s main 12V DC power connector (Cigarette Lighter
connector) has a built-in 10A fuse. Unscrewing the head
connector bolt allow you to access this fuse if exchange
needed. If the pump is connected to a good power source but
cannot be turned on, please check this fuse first. Make sure
you do not lose the fuse spring. The spring is similar to the one
inside a retractable ball pen.
First time use:
You can use your original valve adapter instead of the one included in the pump package if the original one
may provide better inflating experience.
Test Run is necessary before using the pump. You can stop the pump any time by pressing its power button.
Do not leave the pump running unattended even considering its auto stop feature!
To Next Page
