Sears 200.71450 - User Manual

Questions and Answers

N
Nicholas BrownJul 28, 2025
Why does my Sears 200.71450 Battery Charger circuit breaker cycle on and off?
- H
  Heather EwingJul 29, 2025
  The circuit breaker cycles when the current draw is too high. This can be due to several reasons: shorted battery clamps (separate them and check for worn cables, replacing if needed), a shorted battery (have a Sears technician test it), reversed charger leads (correct the connections), or the Volt/Amp Selector Switch set to the START position (correct the setting).
D
Dr. Samantha BlackAug 2, 2025
What to do if Sears 200.71450 ammeter reads less than selected charge rate?
- A
  Aimee ChaseAug 2, 2025
  If the ammeter reads less than the selected charge rate, it could be due to a too long or small gauge extension cord (use a shorter or heavier gauge cord). It might also indicate a weak cell or a sulfated plate in the battery (a sulfated battery may take a normal charge after a period of time; if it doesn't, have a Sears technician test it). Also, the battery may be only partially discharged (continue charging).
M
michaelgarciaAug 6, 2025
Why Sears 200.71450 gives short start cycle when cranking engine?
- B
  Brad SmithAug 6, 2025
  A short start cycle during engine cranking occurs when drawing more than 225 amps for 5 seconds or less, or by not waiting 4 minutes between cranks. Crank time varies with current draw; if it exceeds 225 amps, crank time may be less than 5 seconds. Wait 4 minutes before the next crank.
N
Nathaniel PierceAug 10, 2025
What to do if Sears Battery Charger test meter pointer always to the right?
- N
  Nicole BryantAug 11, 2025
  If the test meter pointer is always to the right, the battery may be severely discharged or the test switch is in the wrong position. Continue to charge the battery for another two hours. If the problem continues, consult a Sears technician. Ensure the test switch is in the proper 6 or 12 volt position.
D
Daniel MathewsAug 14, 2025
How to troubleshoot no reading on Sears 200.71450 ammeter?
- K
  Kathleen GrahamAug 14, 2025
  Ammeter might show no activity at 2 amp setting. If there is no reading on the ammeter, check for poor connections at the battery and ensure the clamps and posts are clean. The battery may not accept a charge due to being excessively run down.
J
Jonathan LopezAug 19, 2025
What to do if Sears 200.71450 test meter isn't reading?
- C
  Curtis JohnsonAug 19, 2025
  If there is no reading on the test meter, the battery may be severely discharged, or the test switch may be in the wrong position. Continue charging the battery for another two hours. If the problem persists, consult a Sears technician. Also, check that the test switch is in the correct 6 or 12 volt position.
D
dawnjonesAug 25, 2025
Why Sears 200.71450 Battery Charger ammeter isn't reading and the fan isn't working?
- H
  Heather MelendezAug 25, 2025
  If there is no reading on the ammeter and the charger fan isn't working, the AC cord or extension cord may be loose, or there may be a poor electrical connection. Inspect the AC outlet and extension cords for a loose fitting plug. Also, check for an open fuse or circuit breaker supplying the AC outlet.