MAINTENANCE
EVERY EVERY EVERY EVERY BEFORE
25 50 100 SEASON STORAGE
HOURS HOURS HOURS
l
Check Brake Operation
Check Tire Pressure
Check Operator Presence & ROS Systems
A Check for Loose Fasteners
C Check/Replace Mower Blades
T Lubrication Chart
0 Check Battery Level
R Clean Battery and Terminals
Clean Debris Off Steering Plate
Check Transaxle Cooling
Check Mower Levelness
Check VoBelts
Check Engine Oil Level
Change Engine Oil (models with oil filter)
Change Engine Oil Imodels without oil filter)
Clean Air RIter
G Clean Air Screen
inspect Muffler/Spark Arrester
N Replace Oil RIter (if equipped)
E Clean Engine Cooling Fins
Replace Spark Plug
Replace Air Filter Paper Cartridge
Replace Fuel Rlter
BEFORE
EACH
USE
v'
J
EVERY
8
HOURS
J
v"
J3
J
J
J
_1,2
j2
_1,2
J
J
v'
J
v"
J
v'
J
v'
- Change more often when operating under a heavy load or in high ambient temperatures
2 - Service more often when operating in dirly or dusty conditions
3 - Replace blades more often when mowing in sandy soil.
4 - Not required if equipped with maintenance-free ba#ery
5 - See Cleaning in Maintenance Section
GENERAL RECOMMENDATIONS
The warranty on this tractor does not cover items that have
been subjected to operator abuse or negligence. Toreceive
fu[[value from the warranty, operator must maintain tractor
as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your tractor.
At least once a season, check to see if you should make
any of the adjustments described in the Service and
Adjustments section of this manual.
At least once a year you should replace the spark plug,
clean or replace air filter, and check blades and belts
for wear. A new spark plug and clean air filter assure
proper air-fuel mixture and help your engine run better
and last longer.
LUBRmCATLON CHART
_-_ SPINDLE ZERK o
_._ FRONT
WHEEL
BEARING
ZERK
SECTOR
GEAR
TEETH
SPINDLE ZERK
FRONT
WHEEL
BEARING
ZERK
ENGINE
MANDREL
ZERKS
BEFORE EACH USE
Check engine oil level.
o Check brake operation.
o Check tire pressure.
o Check operator presence and ROS systems for proper
operation.
Check for loose fasteners.
14
02501
(_ General Purpose Grease
Refer to Maintenance "ENGINE" Section
iMPORTANT: DO NOT OiL OR GREASE THE PIVOT POINTS
WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS
LUBRICANTS WiLL ATTRACT DUST AND DIRT THAT WiLL
SHORTEN THE LiFE OFTHE SELF-LUBRiCATING BEARINGS.
IF YOU FEELTHEY MUST BE LUBRICATED, USE ONLYA DRY,
POWDERED GRAPHITE TYPE LUBRICANT SPARINGLY.
To Next Page
Loading...
