Start by assembling the shrouds. Insert the pin and secure it with the safety splice. When you
nish protect it with the electric tape.
On the bottom part of the shrouds attach turnbuckles to the chainplates as shown on the next
photos. After you insert the safety pin aplly generous ammount of electric tape to prevent the
spinnaker sheets catching in the pin. Make shure that the turnbuckles are maximaly unwinded
before raising of the mast:
When assembling forestay make sure that strap is not wraped and that furler is oriented with
the part that has two rings away from the mast. Also make shure that pin of the furler is
pointing away from the mast tube otherwise it will damage it. You tighten the pin with the pliers.
To Next Page
Loading...
