Seaside 9367 - User Manual

Questions and Answers

A
Austin ValdezAug 7, 2025
What to do if Seaside 9367 Garage Door Opener won't close and the light flashes?
- K
  Kevin RogersAug 7, 2025
  If your Seaside Garage Door Opener won't close and the lights are flashing, it typically indicates an issue with the safety sensors. Here's what to check: * Inspect the sensor wires for any disconnections or cuts. * If the sending sensor's red LED isn't lit, examine the wire and connections for that sensor. * If the sending sensor's LED is lit, verify the wire connections leading to the receiving sensor (green LED). Reconnect or replace any damaged wires as necessary. If your home is pre-wired, inspect the splices. After checking the sensors, try closing the garage door using the remote control or the door control.
A
Adam ClarkAug 12, 2025
Why does my Seaside Garage Door Opener door close, then stop and reverse?
- A
  Andrew WeaverAug 12, 2025
  If your Seaside Garage Door Opener's door closes, then stops and reverses, it usually means there's an obstruction or the door is binding or sticking. If the door is binding or sticking, contact a trained door systems technician. If the door operates smoothly, reprogram the travel.
K
katherine14Aug 17, 2025
What to do if Seaside 9367 runs a little and stops?
- M
  Maurice StevensAug 17, 2025
  If your Seaside Garage Door Opener runs approximately 8-12mm and then stops, it could be due to a communication error with the travel module. To address this: 1. Disconnect all power to the opener. 2. Remove the cover to access the travel module. 3. Check that the wires for the travel module are securely connected. If the wires are connected, the next step is to replace the travel module.
L
Laurie RodriguezAug 22, 2025
How to fix Seaside 9367 if it doesn't automatically open or close?
- J
  Joseph MillerAug 22, 2025
  To troubleshoot a Seaside Garage Door Opener that doesn't automatically open or close, manually open and close the door first. Check for any binding or obstructions that might be preventing smooth operation. After that, reprogram the travel.
S
smithdeborahAug 27, 2025
What to do if Seaside 9367 Garage Door Opener doesn't run due to a travel error?
- C
  Christian SmithAug 27, 2025
  If your Seaside Garage Door Opener isn't running due to a travel error, reprogram the travel.
D
dana29Aug 31, 2025
What to do if Seaside 9367 Garage Door Opener doesn't run because of power supply voltage?
- T
  Tracey ChangAug 31, 2025
  If your Seaside Garage Door Opener isn't running and you suspect it's due to the power supply voltage not being normal, disconnect all power to the unit. Check the power supply. If the power supply is normal, then replace the transformer.