Need help?Do you have a question about the SeasonsComfort SDW2FCMB and is the answer not in the manual?
Read all installation instructions completely and carefully before proceeding.
Follow codes, leave instructions for consumer, note installer/consumer roles, basic skills required, time estimate.
Observe cautions/warnings, wear protective gear, avoid heating element, ensure complete enclosure.
Follow local codes, limit drain hose to 10 ft, connect to waste line with air gap or high loop.
Select Method 1 or 2 based on air gap needs, waste tee height, and drain loop height.
Appliance requires 120V, 60Hz, 15/20A grounded circuit. Wiring must be two-wire with ground.
Connect via grounded wiring system (cable direct) or grounded outlet (power cord) per local codes.
Route cable per page 8, ensure minimum length, use proper wire and strain relief.
Install receptacle, use specified kit, comply with codes, ensure proper cord length of 54-64 inches.
Route wiring through cabinet wall openings. Drill 1.5" hole; use separate hole for power cord.
Connect on left side. Route line from side/rear/floor. Share hole unless power cord is used.
Turn off water, install valve, use 3/8" copper tubing, set heater temp 120-150°F, flush line.
Hold unit, open door slowly, adjust spring tension for balance. Prevent unit tipping.
Lay unit on back, loosen feet, measure and extend legs to set initial height.
Locate and remove the two toekick screws using a Phillips screwdriver.
Turn off power, access junction box, install strain relief, connect wires (white, black, ground), secure cord.
Replace junction box cover, ensuring wires are not pinched. Loosen strain relief if needed for cover fit.
Connect dishwasher wires (white, black, green) to house wiring using wire nuts and strain relief.
Wrap elbow thread with Teflon tape, install onto water valve, position towards floor. Do not overtighten.
Turn unit upright. Slide hose clamp onto the hose end, attach to dishwasher drain outlet, and tighten clamp.
Insert drain hose into cabinet wall hole. Route power cord separately if applicable. Position lines to avoid interference.
Position unit, slide carefully into opening, pull drain hose through. Prevent kinks and panel damage.
Slide unit fully into cabinet, ensure flush with doors. Check wire security and prevent panel damage.
Use a level on door and rack track. Adjust four leveling legs individually for proper balance.
Insert clips into slots, bend brackets, and screw securely to the countertop. For wood or similar materials.
Remove caps, drive screw through dishwasher side into cabinet frame, replace caps. For granite or breakable materials.
Connect water line to 90° elbow using compression nut and ferrule. Ensure no interference with door springs.
Follow local codes. Cut drain hose to fit connection size (5/8" or 1") for air gap, waste tee, or disposal.
Extend hose if needed (max 10 ft total), use coupler/clamps. Secure to air gap, waste tee, or disposal according to method.
Ensure power OFF, clear packaging, check door, wiring, hoses, alignment. Verify water temp and connections.
Turn on power and unit. Run Rinse cycle. Check water flow, leaks, drainage. Run second cycle.
Align toekick with legs and screw into place. Ensure correct orientation with junction box.
This document provides installation instructions for Seasons dishwashers, specifically models SDW2FCMB, SDW2FCMS, and SDW2FCMW. It emphasizes safety, proper installation techniques, and necessary tools and materials.
The Seasons dishwasher is designed for residential kitchen use, intended to be enclosed within a standard cabinet unit. It features a heating element to heat water for washing. The installation process covers preparing the enclosure, connecting water and drain lines, and electrical hookup, ensuring proper operation and drainage.
General| Brand | SeasonsComfort |
|---|---|
| Model | SDW2FCMB |
| Category | Dishwasher |
| Language | English |
To Next Page
