STEP 6. Attach the female disconnects to each of the male terminals
on the Interrupt Switch.
STEP 7. Attach the other end of one wire to the Emergency Stop Wire,
using a suitable insulated wire connecting device. (See Reference
Table 1 and Diagram B.)
STEP 8. Attach the other end of the second wire to the ground point,
using a suitable insulated wire connection deice as shown in Diagram
B below.
STEP 9. Recheck all connections. Install the Lanyard with the Fork Clip
seated over the Plunger.
STEP 10. Replace engine cover and reconnect battery.
STEP 11. Start engine. If engine does not start: a) disconnect battery;
b) remove engine cover; c) recheck all electrical connections;
d) replace engine cover; and e) restart engine.
Remove Lanyard. Engine should stop immediately.
If engine fails to stop, recheck all wiring. Should the engine fail to start or
stop or resume running with the lanyard fork removed, consult your local
marine dealer for assistance.
CAUTION
WIRE COLOR TABLE
FOR LATE MODEL OUTBOARDS
ENGINE COLOR
Daihatsu Solid Brown
Evinrude
Before 1969
Black with Yellow Stripe
Solid Blue
Force Solid White
Johnson
Before 1969
Black with Yellow Stripe
Solid Blue
Mariner Black with Yellow Stripe
Mercury Black with Yellow Stripe
Nissan Solid Brown
OMC
Before 1969
Black with Yellow Stripe
Solid Blue
Suzuki Solid Brown
US Marine
Blue with Black Stripe or
Solid Blue
Yamaha Black with Yellow Stripe
Reference Table 1.
Diagram B.
Outboard Wiring.
Page 12 of 20 SeaStar Solutions Installation Instructions and Owner’s Manual Telephone: 610-495-7011
To Next Page
Loading...
