INSTALLATION (SIDE MOUNT AND CENTER MOUNT)
STEP 1. Cut opening in gunwale per included Mounting template.
Note: Control is designed to be installed without removing the lever.
STEP 2. Align the mechanism (inside the gunwale) and the bezel base
(outside the gunwale) with the 4 screw holes.
STEP 3. Install the 4 quarter inch bolts and lock washers through the
bezel and into the mechanism mounting plate.
bezel base.
web: www.seastarsolutions.com SeaStar Solutions 640 North Lewis Road, Limerick, PA 19468 USA Page 13 of 20
STEP 4. Install the left and right side bezel covers. Rotate the lever
forward or reverse if required.
Note: To remove covers, insert a small at head
screwdriver into the lower grooves and gently pry the
covers forward.
INSTALLATION (TOP MOUNT)
STEP 1. Cut opening in console per included Mounting Template.
STEP 2. Align the mechanism and gasket with the four screwholes.
STEP 3. Install the four bolts, lockwashers and nuts through the
STEP 4. Install the bezel cover.
Note: To remove the bezel cover, apply rearward force on the
front of the cover while rotating the front counter clockwise
(towards the lever) until the front snap disengages. Then apply
forward force to the rear of the bezel while gently lifting the
assembly and rotating the rear clockwise until the rear snap
disengages.
DO NOT APPLY EXCESSIVE FORCE as this may result in
breakage of the snap features.
To Next Page
Loading...
