Seastar Solutions ABYC CHX8000 Series - Control Cable Installation Details; Bend Radius and Cable Support; Cable Routing Precautions

Installation of Cables
A. BEND RADIUS. When routing the control cables, select a path with
the minimum number of bends, making the bends as large as
possible. Sharp or frequent bends will result in difcult throttle or shift
control, loss of motion, and premature cable wear. DO NOT MAKE
BENDS OF LESS THAN THE RECOMMENDED MINIMUM BEND
RADIUS AS NOTED BELOW.
B. SUPPORTING THE CABLE. Do not tie or clamp the cable within 36
inches of the control. When supporting the cable beyond 36 inches
of the control, cables should be loosely clamped or tied for support at
regular intervals.
Cable Type
Minimum
Bend Radius
Standard 8"
Xtreme 4"
For best performance, SeaStar Solutions recommends using Xtreme
cables with this control.
Cables must not be bundled together with electrical wiring.
Cables must not rest on sharp edges which can cause chang.
CAUTION
C. CABLE ROUTING. Cables shall not be installed in areas of excess
heat such as on, or close to, exhaust manifolds where temperatures
may exceed 212°F (100°C).
web: www.seastarsolutions.com SeaStar Solutions 640 North Lewis Road, Limerick, PA 19468 USA Page 5 of 20