EasyManua.ls Logo

Seat Leon 2010 - Page 146

Seat Leon 2010
307 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Seats and storage compartments144
Rear shelf
Removing the shelf
Unhook the loops fig. 104 from housings
Extract the cover from its slot, in its rest position and pull
outwards.
WARNING
Do not place heavy or hard objects on the rear shelf, because they will
endanger the vehicle occupants in case of sudden braking.
Caution
Before closing the tailgate, ensure that the rear shelf is correctly fitted.
An overloaded boot could mean that the rear shelf is not correctly seated
and it may be bent or damaged.
If the luggage compartment is overloaded, remove the tray.
Note
Ensure that, when placing items of clothing on the luggage compartment
cover, rear visibility is not reduced.
Roof rack*
Please observe the following points if you intend to carry loads on the roof:
For safety reasons, only luggage racks and accessories approved by SEAT
should be used.
It is imperative to precisely follow the fitting instructions included for the
rack, taking special care when fitting the front bar in the holes designed for
this and the rear bar between the marks on the upper part of the rear door
frame while respecting the correct direction of travel indicated in the installa-
tion manual. Not following these instructions may damage the bodywork.
Pay special attention to the tightening torque of the attachment bolts and
check them following a short journey. If necessary, retighten the bolts and
check them at regular intervals.
Distribute the load evenly. A maximum load of 40 kg only is permitted for
each roof rack system support bar, the load must be distributed evenly along
the entire length. However, the maximum load permitted for the entire roof
(including the support system) of 75 kg must not be exceeded nor should the
total weight of the vehicle be exceeded. See the Technical Data section.
When transporting heavy or large objects on the roof, any change in the
normal vehicle behaviour due to a change in the centre of gravity or an
increased wind resistance must be taken into account. For this reason, a suit-
able speed and driving style must be used.
For those vehicles fitted with a sunroof*, ensure that it does not interfere
with the load on the roof rack system when opened.
Fig. 104 Rear shelf
A
B
A
A
leon_EN.book Seite 144 Donnerstag, 15. April 2010 9:19 09

Table of Contents

Related product manuals