Need help?Do you have a question about the Seat Leon 2013 and is the answer not in the manual?
General| Brand | Seat |
|---|---|
| Model | Leon 2013 |
| Category | Automobile |
| Language | English |
General safety precautions for working on vehicles, including high-voltage systems and subframes.
Procedures for common repairs like shock absorbers, steering rack, bolts, and electrical components.
Guidelines for inspecting vehicles after accidents, focusing on running gear and tyres.
Procedures for safely releasing gas and draining shock absorbers.
Overview of fitting locations for front axle components like subframe, suspension strut, and drive shaft.
Detailed procedures for removing, installing, and repairing the subframe and related parts.
Procedures for removing, installing, and repairing suspension struts and upper suspension links.
Assembly overview and procedures for lower suspension links, swivel joints, and bonded rubber bushes.
Assembly overview and procedures for removing and installing wheel bearings and housings.
Overview and procedures for removing, installing, and dismantling drive shafts.
Overview and procedures for removing and installing the rear axle and related components like axle beam.
Assembly overview and procedures for renewing bonded rubber bushes for the axle beam.
Assembly overview and procedures for removing, installing, and fixing the subframe.
Procedures for removing and installing the anti-roll bar and its coupling rod.
Assembly overview and procedures for transverse links, track rods, and eccentric bolts.
Assembly overview and procedures for suspension struts, shock absorbers, and springs.
Assembly overview and procedures for wheel bearings and trailing arms.
Overview and procedures for removing, installing, and dismantling drive shafts.
Assembly overview and procedures for the electronically controlled damping system, control units, and sensors.
Notes, test requirements, preparation, and procedures for wheel alignment.
Identifying and rectifying causes of rough running related to wheels and tyres.
Procedures for calibrating the adaptive cruise control system.
Procedures for calibrating the front camera for driver assist systems.
Assembly overview and procedures for removing and fitting the steering wheel and airbag unit.
Assembly overview, checking, handling, and removal/installation of the steering column and related control units.
Assembly overview and procedures for removing, installing, and repairing the steering rack and its components.
Information on removing and installing the steering angle sender.
To Next Page
