Tightening clamp on small diameter of inner/outer joint
6.7 Checking outer constant velocity joint
The joint is to be dismantled to renew the grease if it is heavily
soiled, or to check the running surfaces of the balls for wear and
damage.
Removing
– Before dismantling, mark position of ball hub in relation to ball
cage and joint body with an electric scriber or oil stone.
– Swing ball hub and ball cage.
– Remove the balls one by one.
– Turn cage until the two rectangular windows -arrow- lie on joint
body.
– Take out cage with hub.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
6. Drive shaft 137
To Next Page
Loading...
