Driving166
Deactivating and activating the Start-Stop function
Every time the ignition is switched on, the Start-Stop function is
automatically switched on.
Manually deactivating the Start-Stop function
–Press the ⇒ fig. 118 located in the centre console. When the
Start-Stop function is deactivated, the pushbutton indicator
lights.
– If the Start-Stop function is operating then the engine starts
immediately.
Manually activating the Start-Stop function
–Press the ⇒ fig. 118 located in the centre console. The indi-
cator on the button will go out.
Driver messages
When the engine is turned off by the Start-Stop function, this is displayed on
the instrument panel.
Note
There are different versions of the dash panel; the display of indications on
the screen may differ.
Fig. 118 The Start-Stop
function button.
A
A
Fig. 119 Display on the
instrument panel during
Start-Stop function opera-
tion.
leon_EN.book Seite 166 Donnerstag, 15. April 2010 9:19 09
To Next Page
Loading...
