Need help?Do you have a question about the Seatcraft Equinox and is the answer not in the manual?
General| Category | Home Theater Seating |
|---|---|
| Base Lighting | Yes, LED Base Lighting |
| Upholstery Material | Top Grain Leather |
| Reclining Mechanism | Power Recline |
| Headrest | Powered Headrest |
| Cupholders | Yes |
| Storage | Armrest Storage |
| USB Charging Ports | Yes |
| Lumbar Support | Powered Lumbar Support |
Connect the powered headrest female cable to the powered headrest male cable and the powered lumbar female cable to the powered lumbar male cable.
Slide the backrest female brackets onto the backrest male brackets until you hear a click on both sides.
Plug the power adapter cable into the power adapter and connect the adapter to the power recline cable.
Open the in-arm storage to find the tray table and place it into the accessory mount.
Push to turn the ambient base lighting and the lighted cupholders on or off.
Hold for over 5 seconds to save a sitting position, or push to recall it.
Hold to return the seat, headrest, and lumbar to their upright positions.
Plug in any USB-powered device to charge it.
Tilt UP/DOWN to adjust the powered headrest to your desired position.
Slide FORWARD/BACKWARD to set the powered recline to your preferred position.
Tilt UP/DOWN to fine-tune the powered lumbar support to your liking.
Check Power Adapter connection. Ensure the green light on the adapter is illuminated.
Check headrest cable connections and Power Adapter connection. Ensure adapter light is on.
Check lumbar cable connections and Power Adapter connection. Ensure adapter light is on.
Check Power Adapter connection. Ensure the green light on the adapter is illuminated.
Pull up the locking tab on the backrest female bracket and pull the backrest upward.
Connect the SoundShaker cable to the optional SoundShaker amplifier kit.
To Next Page
