Need help?Do you have a question about the Sebury BC-2000 and is the answer not in the manual?
Connect necessary cables to the harness, tape unused wires, and secure the front cover.
Defines the function of each terminal in the wire connector.
Enter programming mode by pressing * 9999 # within 5 seconds.
Press # to save modifications and exit engineer programming mode.
Procedure to add user cards and their corresponding identification codes.
Options to delete all user cards or individual user cards.
Select between card only, card and password, or valid code operation.
Configure the door relay output time from 0 to 99 seconds.
Configure the alarm signal output time from 0 to 99 minutes.
To Next Page
General
