Model 767 15
GB
3. Before you start…
Unpacking
The scope of supply includes:
• Weighing platform
• Column with display head
•1 WAF 5 Allen key
•2 Screws
• Battery holder containing
4 mignon-type AA 1.5 V batteries
•1 set of operating instructions
Fitting the column
The column with the LCD display can be fitted in two positions, allowing you to determine
in which direction the display is legible - facing either towards or away from the platform.
– Place the column in the recess, facing it
in the desired direction.
– Screw the column to the weighing plat-
form from underneath.
If necessary, lay the scale carefully on
its side to tighten up the screws.
– Connect the plug of the connecting
cable to the rear of the scale.
– Then place the scale upright again.
Power supply
The scale is powered exclusively by batteries.
The LC display has a low power consumption – 120.000 weighing operations can be per-
formed with one set of batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the battery compartment closure
towards “Battery” and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery compart-
ment.
– Close the cover and then turn the scale
back up the right way.
Note: the scale is prepared for use with a seca mains unit which is available as
an accessory.
To Next Page
Loading...
