Seca 856 - Before you start...; Unpacking; Power supply; Check polarity is correct

Model 856 13
GB
3. Before you start…
Unpacking
Remove the packaging and place the scale on a firm, level surface.
Power supply
The scale is powered exclusively by batteries.
If or
 appear in the display, you should change the batteries. You need 4
1.5 V type AAA round-cell batteries.
– Unscrew the bolts which secure the lid of
the battery compartment, and remove.
– Insert the new batteries in the battery
compartment.
Check that polarity is correct!
– Replace the lid of the battery compart-
ment, and bolt this firmly in place.
– Turn the scale to the upright position.
4. Operation
Controls and displays
press briefly ➔ activate/deactivate pre-tare function
hold down ➔ store the tare value
press briefly ➔ activate/deactivate hold function
hold down ➔ set display to zero, activate/deactivate tare function
press briefly ➔ Switch scale on and off
hold down ➔ switch between g and oz (variant-dependent)
Pretare